Is it possible to add a network sensor from the Genians NAC web gui to monitor on a trunk port? I see that the admin guide explains doing this in the initial configuration, but is it possible to add an additional network sensor after you have stood up the server/sensor.
I attempted to do this by using the cli command: interface eth1 vlan
Then adding the vlan id's on the trunk port, but this does not seem to have worked for monitoring network traffic on those vlans. Additionally I added IP addresses for the different subnets on those vlans for the interface, but again this does not seem to have worked.
Just to clarify - the eth1.101 and eth1.102 are working properly and monitoring the subnets/vlans that they are assigned and identifying nodes in their subnets. The eth1 address does not seem to be reachable (i.e. address does not respond to pings and not monitoring and identifying nodes in the subnet).